Reviews for Goodman 4 Ton 15.2 SEER2 80% AFUE 80,000 BTU Furnace and AC System - R32 Upflow

We just had our units installed and they seem great so far.

Goodman is the way to go !
I have a 2 1/2 , 3 , 5 ton
All have worked as expected great

The condenser is VERY noisy.
1. A compressor sound blanket would have helped a lot. I would have gladly paid $100 for the add.
2. There's a small section of low pressure pipe that's not insulated causing condensation leaking inside the condenser.

The hardest part of this installation for me was cutting out a bottom hole and sealing up the side return inlet on a steal prefabricated bottom plenum. I didn’t want to redo or add to the top plenum, so I ordered a bottom base that matched the Goodman color since this furnace was about 5 inches shorter than the old one. Once that was complete and the AC coil was strapped up, pulling out the old furnace and installing this one was a breeze. I did swap out the electrical housing though because I just wanted an easy transition and the plastic housing in this one was too thick for the old screw in wire retainer, the old sheet metal one worked better for my situation. It doesn’t come with an air filter rack, so I reused the one from the old unit. In conclusion, it’s a very easy plug and play unit once you’re ready to install. You’ll need a 1/2 inch diameter 2 inch long gas line and a 90 degree elbow for the initial phase of the gas inlet, plus whatever length is best for your situation for the run out of the furnace. The electrical wires are basic black/white/green. Always remember to take an up close picture of your thermostat wires before removing them from the old unit so you’ll be able to put them back in the exact order.

Awesome unit

Awesome unit

Beyond pleased with the WHOLE experience

Goodman 96% efficiency furances deliveried in a few days. Great units, efficient, quiet. Place 3 separate units in my rental. Work great. Wish all purchases were this good.

I had never done this before, but thanks to YouTube I completely installed this furnace on my own. Bending and installing the sheet metal was the only unknown. With a few basic tools the metal can be done. I would do it again since it saved me $2k.

great service and great shipping,no damage on six units.