Superior Radiant T Series - TXR High Efficiency Two Stage Infrared Tube Heater - Natural Gas - 160,000 / 205,000 BTU - Stainless Steel Sealed Burner - 70 ft Stainless Steel Tube, Aluminum Reflector Kit

This Superior Radiant 70' S/S Tube, Alum Reflector Kit is a full Infrared Heat Exchanger, complete with combustion tubing and parabolic reflectors, built to fit burner models TXR, UXR - 205,000 / 220,000 BTU.

This kit contains the following:

• 1 - 10' Stainless Steel Flanged Combustion Tube UT005
• 6 - 10' Stainless Steel Tube Length(s) CT030
• 7 - 10' Parabolic Aluminum Reflector Segment(s) CR001
• 6 - Stainless Steel Tube Coupling(s) CR005
• 1 - Vent Connector (without clamps) CS019
• 2 - Reflector End Caps CR002A
• 8 - Stainless Steel Tube & Reflector Hangers CR003S
• 14 - Stainless Steel Reflector Brackets CR004S
• 14 - Stainless Steel Spring Clips - Reflector Bracket CR009S

Series T heaters feature optimal comfort and energy savings with SRP’s two-stage technology. High-low capability allows for quicker recovery on the high fire and economical steady operation on the low fire.

Model TA - Heavy duty industrial/commercial two-stage infrared heater.

Model TX - Enclosed burner design further enhancing all of the great features of the TA for hard service applications.

Model TXR - As the Model TX with extra features for harsh and outdoor environments. TXR includes a potted module, sealed burner housing and heat-treated aluminized tubes. Stainless steel available.

About this Product

The model TXR includes all of the features in a Model TX plus... the burner box is sealed for rugged, harsh environments and heat-treated aluminized is standard tube supplied. CSA approved for outdoor use.

Key Features

• • TXR features a totally enclosed burner construction
• • Two stage heater – Approved for outdoor use
• • 40,000 to 220,000 btu/h
• • Natural Gas or LPG
• • Configurations of “U” and “L”, horizontal or 45°
• • Separated controls compartment – electronics out of air stream, burner can run during servicing
• • Self diagnostic ignition module
• • Parabolic aluminum reflectors – Most efficient in industry
• • Direct spark ignition
• • Vented or unvented
• • Jet Stream burner – improved heat distribution, better combustion
• • PSC Blower Motor
• • Heavy duty couplings – no leaks, cannot be over tightened
• • Operating status lights
• • Low voltage controls
• • 24v Direct Wire for Thermostat
• • TXR features burner box sealed for outdoor conditions
• • Rubber gaskets are used instead of fiber
• • Silicone used to seal corners and joints
• • Weather resistant electrical components used for exterior connections
• • Stainless steel burner boxes available as well as tubing and reflectors
• • Units are wind resistant
• • Three-year warranty on all components
• • Five-year warranty on hot rolled heat exchanger
• • Seven-year warranty on aluminized heat exchanger
• • 10-year warranty on aluminized heat exchanger with post purge feature