3 Ton 15.2 SEER2 Goodman Air Conditioner with Vertical 24.5" Cased Coil

Thermostatic Expansion Valves (TXVs) are:

• Required for 14 SEER or higher split system heat pumps
• Required for many condensers or heat pump systems designed for R-410A refrigerant
• An optional upgrade for any other air conditioner or heat pump systems

Your system will operate better and with higher efficiency with a TXV kit. This kit offers more control over how much liquid refrigerant enters the evaporator coil. The valves only allow a certain amount of liquid into the coil to make sure that all liquid that enters completely evaporates. This allows for the prevention of too little liquid from entering the evaporator which would make the system run less efficiently. It also stops too much liquid from entering the evaporator which can cause excess in the lines. Thermostatic Expansion Valves are provide multi-position mounting on the evaporator coil inlet and are consistent, efficient and virtually hassle-free. Select the TXV to match the tonnage of your air conditioner or heat pump, as well as to match the type of refrigerant your systems uses, R-22 (standard) or R-410A (new alternative)

This capacitor gives an extra "jolt" of electricity upon startup to push the refrigerant against higher head pressures that are present with a TXV system. When using a TXV, manufacturer's recommend also installing a hard-start in your heat pump or condenser. If a hard-start capacitor is not installed, the equipment compressor has a possibility of having trouble getting started.

Compatibility

Please note that this is not an exhaustive list. Use Ctrl+F to simplify your search. This part is compatible with the following models:

OVERVIEW

With the CAPFA4226D6 evaporator coil, Goodman provides an enhanced comfort to your home. With its ability to work with AC-only systems or with heat pumps and its ability to be installed in both the upflow or downflow orientations, the CAPFA4226D6 is designed to be versatile in design and to provide an efficient comfort at a low cost.

QUICK FACTS

• 3.5 ton evaporator coil
• Installable in the upflow or downflow configurations
• Usable with either a heat pump or an AC-only condenser
• Low air leakage
• Check flowrater expansion device for use in any application

3.5 Tons

The Goodman CAPFA4226D6 evaporator coil is rated for a 3.5 ton output. In many system configurations, this coil may be larger in tonnage than its paired condenser. This is intentional, to maintain the overall efficiency of the entire system. Please note that in order for this coil to function, a furnace or blower and a condenser is required, all sold separately.

Warranty

The CAPFA4226D6 coil is covered under Goodman’s standard 10 year parts warranty when the unit is installed following your state and local codes, the coil is paired with a compatible condenser, and the entire system is registered online through the manufacturer.

Installation and Durability

The Goodman CAPFA4226D6 evaporator coil is able to be installed in upflow and downflow applications. With its rust-resistant, thermoplastic drain plan, water retention rate is significantly lower than previous models. For even more enhanced durability, the cabinet is made of a strong galvanized-steel with a leather-grain finish. If you ever need to perform maintenance on your coil, there is a split-seam on the front of the casing for easy internal access. Please note that this coil will not work as a replacement for any single-piece air handler coils.

Enhanced Comfort

The CAPFA4226D6 evaporator coil’s foil-faced insulation lowers air leakage, increasing the amount of air flow going into your ductwork, keeping you more comfortable while decreasing the unit’s run time. With compatible equipment, the CAPFA4226D6 evaporator coil lives up to Goodman’s enhanced comfort and efficiency standards at a reasonable price.